FLEX-Communication

From ErikaWiki

Jump to: navigation, search

The FLEX-Communication palette:

Symbol Description
Usb send.png This block controls the sending of a packet through the USB connection for the FLEX FULL Board. The internal parameter specifies the channel(from 0 to 14).
Usb read.png This block controls the reception of a packet through the USB connection for the FLEX FULL Board. The internal parameter specifies the channel(from 0 to 14).
Can in.png This block controls the sending of a packet on a CAN bus for the FLEX Board. The internal parameters specify the message ID and the number of the output lines of the block.
Can out.png This block controls the reception of a packet on a CAN bus for the FLEX Board. The internal parameters specify the message ID and the number of the input lines of the block.
Can cfg.png This block configures the FLEX CAN driver. The internal parameters specify the message identifiers (only 5 different IDs are supported at the moment).
Serial send.png This block controls the serial sending through the RS-232 protocol for the FLEX Board. The internal parameters specify the serial port and the baud-rate.
Serial receive.png This block controls the serial reception through the RS-232 protocol for the FLEX Board. The internal parameters specify the serial port and the baud-rate.
802154 send.png This block controls the serial sending through the 802.15.4 protocol for the FLEX Board. The internal parameters specify the data ID, the destination address and the usse of GTS.
802154 receive.png This block controls the reception of a packet through the 802.15.4 protocol for the FLEX Board. The internal parameters specify the data ID, the source address.
Coord.png This block sets the Coordinator parameters for a 802.15.4 based communication for the FLEX Board. The internal parameters specify the coordinator settings.
Device.png This block sets the Device parameters for a 802.15.4 based communication for the FLEX Board. The internal parameters specify the device settings.
Udp send.png This block controls the data sending through the UDP protocol for the FLEX Board. The internal parameter specifies the number of the input lines of the block.
Udp receive.png This block controls the data reception through the UDP protocol for the FLEX Board. The internal parameter specifies the number of the output lines of the block.
Udp cfg.png This block sets the socket parameters for an UDP based communication for the FLEX Board. The internal parameters specify the FLEX IP address, the FLEX UDP socket port, the FLEX IP subnet mask, the FLEX Gateway address, the FLEX primary DNS address, the FLEX secondary DNS address, the PC IP address and the PC UDP socket port.
Personal tools